Cutting Grass; Lawn Edge Trimming; Cleaning And Maintenance; Cleaning - Parkside Prta 20-Li B2 Traduction Des Instructions D'origine

Table des Matières
Les langues disponibles
  • FR

Les langues disponibles

GB
IE
NI
sure that the spool is not touch-
ing any stones, scree, or other
foreign objects.
• Switch on the trimmer before you
approach the grass that is to be
cut.
• Do not overload the trimmer dur-
ing operation.
• Avoid contact with obstacles
(stones, walls, fences, etc.). The
nylon thread on the spool would
wear out quickly.
• Avoid using the device in bad
weather, especially if there is a
danger of lightning!

Cutting grass

Cut tall grass by a series of levels from top
to bottom.

Lawn edge trimming

Setup for edge trimming:
To trim lawn edges, slowly move the appli-
ance along the lawn edges.
• Handle rod: 90° or 180°
)
(see
• Cutting angle position 7
ƒ
)
(see
• Spacer bow in parking position
Cleaning and
maintenance
Warning! Risk of injury from
moving dangerous parts!
16
Cut the grass by
swaying the trimmer
sideways to the
right and left. Cut
slowly while the
trimmer is tilted for-
wards by approx.
30°.
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush. Do not
use cleaning agents or solvents. You
may otherwise irreparably damage the
appliance.
• After every trimming session, remove
grass and soil from the protective cover
and the trimming assembly.

General maintenance

• Prior to every use, check the appliance
for obvious defects such as loose, worn
or damaged parts. Ensure that the
screws in the cutting device are firmly
in place.
• Check covers and safety devices for
damages and correct installation. Re-
place as necessary.
Table des Matières
loading

Ce manuel est également adapté pour:

334231 1907

Table des Matières