Disposal; To Discard The Product; Technical Data - Meec Tools 022352 Traduction Des Instructions D'origine

Problem
The product does not cut.
The result of the cut is
unsatisfactory.
There is excessive noise or
vibration.
9

Disposal

9.1

To discard the product

● Make sure that you follow local regulations when you
discard the product. Do not burn the product.

10 Technical data

Specification
Voltage
Speed
Saw capacity 45°/90°
Saw capacity 90°/45°
Saw capacity 45°/45°
Saw capacity 90°/90°
Blade capacity
Noise levels
1
Sound pressure level, LpA
Sound power level, LwA
Warning! Always wear hearing protection!
Warning! The actual vibration and noise level when
using tools may differ from the specified maximum value,
depending on how the tool is used and the material. It is
therefore necessary to determine which safety precautions
are required to protect the user, based on an estimate of
exposure in actual operating conditions (taking into account
all stages of the work cycle, e.g. the time when the tool is
switched off and when it is idling, in addition to the start-up
time).
1 The declared values for vibration and noise, which have
been measured according to a standardized test method,
can be used to compare different tools with each other and
for a preliminary assessment of exposure. The measurement
values have been determined in accordance with
EN 62841-3-9:2015.
Possible cause
The saw blade is worn or damaged.
The saw blade is dull or damaged.
The cutting angle is not correct.
The saw blade is not suitable for the material.
The saw blade is overheated.
The saw blade is dull or damaged.
There are loose bolts or nuts.
Value
18 V
4500/min
80 x 60 cm
120 x 30 cm
80 x 30 cm
120 x 60 cm
Ø210 mm
91.7 dB(A), K=3 dB
104.7 dB(A), K=3 dB
Action
Replace the saw blade. Refer to "4.3 To
attach and change the saw blade" on page
8.
Adjust the bevel and mitre cutting angle.
Change to a correct saw blade.
Let the saw blade become cool.
Replace the saw blade. Refer to "4.3 To
attach and change the saw blade" on page
8.
Tighten loose bolts and nuts.
11