Connecting To Video Equipment With Rgb Or S-Video Inputs - Sony DXC-9000 Mode D'emploi

Basic System Connection

Connecting to Video Equipment With RGB or S-Video Inputs

Camera cable: CCXC-9DB (D-sub 9-pin)˜BNC
connectors), or CCMC-9DS (D-sub 9-pin) ˜
BNC, S-video connectors)
DXC-9000
FREEZE 
MENU FUNCTION DATA
LENS
UP
WHITE
SOURCE BARS
DOWN 
CCU
SCAN
RGB/SYNC


REMOTE
VIDEO OUT
DC IN/
EXT CTRL
VBS

Camera cable CCXC-9DD (D-sub
9-pin˜D-sub 9-pin)
DC IN/VBS
CCDC-5/10/25/50A/100A cable or
CCMC-12P02/05/20/25 cable
If a CCMC cable is used, the S-video signal is
also output from the S-video output of the
a) When using a video monitor without a sync signal input connector,
the unit can be set to output a sync signal with the G signal.
For details of how to add the G signal, see "G SYNC" of PAGE
3 menu (on page 84).
b) This setup is for connecting a composite video (VBS) connector.
To send separated Y/C signals to the S-video input of video
equipment, use a CCMC-9DS camera cable.
106
RGB/SYNC
or
1
2
R input
G input
B input
Sync input
Composite video (BNC) or
S-video input (4-pin) b)
Set the MODE selector
to the "1" position. CMA-D2/D2MD
camera adaptor
CAMERA (4-pin or 12 pin)
For details on switching camera output between VBS (composite
video) and Y/C, see "D-SUB Sync" of PAGE 3 menu (on page
85).
c) When connecting to a multi-scan monitor or multi-scan printer, set
the scan mode to VGA.
For details of how to set the scan mode, see "Setting the Scan
Mode" on page 97.
RGB monitor, multi-scan
monitor, multi-scan printer
image processor, etc.
a)
RGB/SYNC
Computer, image
processor, etc.
AC IN
Power cord
c) ,