Nilfisk Ecolab Hybrid Typhoon Mode D'emploi page 23

Table des Matières

Les langues disponibles

C9 High Motor

1. Water supply valve not closed

Temp. Compressor

C20 Low Sensor

1. Pressure signal from pumptop sensor, out of range

Signal P-Pumptop

C21 Low Sensor

1. Temparature signal from pumptop, sensor, out of range 1. Press "off" button

Signal T-Pumptop

C22 Low Sensor

1. Pressure signal form inlet sensor, out of range

Signal P-Air

C23 Low Sensor

1. Temperature signal from inlet sensor, out of range

Signal T-Air

C25 Low Sensor

1. Signal from flow sensor, out of range

Signal flow

C30 High Sensor

1. Pressure signal from pumptop sensor, out of range

Signal P-Puumptop

C31 High Sensor

1. Temperature signal from pumptop sensor, out of range

Signal T-Pumptop

C32 High Sensor

1. Pressure signal from inlet sensor, out of range

Signal P-air

C33 High Sensor

1. Temperature signal from inlet sensor, out of range

Signal T-Air

C35 High Sensor

1. Signal from flow sensor, out of range

Signal flow

C40 Sensor Load

1. Supply voltage for pumptop sensor too low.

Pumptop Sensor

2. Pumptop sensor using too much current

C41 Sensor Load

1. Supply voltage for inlet sensor too low

Air sensor

2. Inlet sensor using too much current

C43 Sensor Load

1. Supply voltage for flow sensor too low

Flow sensor

2. Flow sensor using too much current

1. Secure sufficient air supply to

the valve.

2. Contact your local service

technician.

1. Press "off" button