Technical Data; Intended Use; Electrical Connection And Operation; Extension Cable - Festool LS 130 EQ Guide D'utilisation

tools, with sharp cutting edges are less likely to
bind and are easier to control.
21 Check for misalignment or binding of
moving parts, breakage of parts, and any
other condition that may affect the tools
operation. If damaged, have the tool
serviced before using. Many accidents are
caused by poorly maintained tools.
22 Use only accessories
recommended by the manufacturer for
your model. Accessories that may be suitable
for one tool, may become hazardous when used
on another tool.
23 Tool service must be performed only by
qualified repair personnel. Service or
maintenance performed by unqualified
personnel could result in a risk of injury.
24 When servicing a tool, use only identical
replacement parts. Follow instructions in
the Maintenance section of this manual. Use
of unauthorised parts or failure to follow
Maintenance instructions may create a risk of
electric shock or injury.

Technical data

Wattage
No load speed
Strokes per minute
Sanding stroke
Sanding base 80 x 130 mm (3.15 x 5.12 in.)
Weight
Safety level
UL 735, CSA C22.2 No. 745
The specified illustrations can be found at the
beginning of the operating instructions.
Symbols
V volts
A amperes
Hz hertz
W watt
~ alternating current
n no load speed (revolutions)
0
Class II Construction
rpm revolutions per minute
spm strokes per minute

Intended use

The tools are designed for sanding wood,
plastic, composite materials, paint / varnish,
filling material, metal and similar materials.
Material containing asbestos must not be
processed with these tools.
that
Service
4 000 - 6 000 rpm
8 000 - 12 000 spm
4.0 mm (0.16 in.)
1.7 kg (3.7 lbs)
/ II acc. to
sanding, sawing, grinding, drilling and other
construction activities contains chemicals
known (to the State of California) to cause
cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
•lead from lead-based paints,
•crystalline silica from bricks and cement and
are
other masonry products, and
•arsenic and chromium from chemically-
treated lumber.
The risk from these exposures varies,
depending on how often you do this type of
work.
Thanks to its linear sanding movement, the LS
130 EQ is ideally suited for sanding battens,
260 W
straight profiles and in rebates.
The machines must not be damp nor operated
in a damp environment for electrical safety
reasons. The machines may only be used for
dry sanding.
for any damage or accidents resulting from
incorrect use.

Electrical connection and operation

The mains voltage must correspond with the
voltage on the rating plate!
before connecting or disconnecting the power
cable!
See Fig. 2 for connection and disconnection of
the power cable.
Switch (1.2) is an on/off switch. For continuous
use it can be engaged with the lateral locking
button (1.1). Pressing the switch again releases
the lock.
If an extension cable is required, it must have
a sufficient cross-section so as to prevent an
excessive drop in voltage or overheating. An
excessive drop in voltage reduces the output
and can lead to failure of the motor. The table
shows the correct size to use, depending on
5
Various dust created by power
To reduce your exposure to these
chemicals: work in a well
ventilated area, and work with
approved safety equipment, such
as dust masks that are specially
designed to filter out microscopic
particles.
The user bears sole responsibility
Always switch the machine off

Extension cable