Care And Storage - Beurer FCE 60 Mode D'emploi

CaUTIon
Do not use the device:
• if your skin is swollen or irritated
• in the case of burns, circulation problems, diabetes, tuberculosis, tumours, bruises, trigeminal
neuralgia
• if you have a pacemaker
• if you are suffering pain, the cause of which is unknown
If you have any doubts, consult your doctor.
• Before putting the device into operation, ensure the batteries are fully charged. The first charging pro-
cess takes approx. 5 hours. Every subsequent charging process lasts approx. 2 hours.
• Insert the mains adapter cable into the connection socket on the base station.
• Position the base device in the base station in such a way that the charging contacts are touching each
other. The charger indicator lights flash to indicate the charging process.
• Select the attachment you want to use, position it on the fastening device and then turn
the fixing device in a clockwise direction to secure.
• The hard-brush attachment is used as an exfoliation attachment. It can be used to remove
flakes of skin and dead skin cells.
• The soft-brush attachment is used for cleaning and caring for both flat areas of skin, such
as on the neck and forehead, and protruding areas of skin such as the nose.
• You can use the nub attachment together with cleansing gel as the final part of your facial
treatment if you have greasy skin, or you can use it on your forehead and nose if you have
combination skin, among other applications.
• Switch on the device using the on/off button. You can increase the intensity of vibration of
the facial scrubber by pressing the on/off button again.
WarnInG
• People with sensitive skin may experience reactions involving swelling or irritation of the skin. If
required, test the device prior to use on a less sensitive area, e.g. on the underside of your arms.
Use it for only a short time to begin with, to keep the risk of reactions to a minimum.
• Do not use the device directly next to eyes. The skin near your eyes is thinner and more sensitive.
• Do not press the attachments onto your skin with too much force, as this slows down the movement
and it could damage the sensitive facial skin.
• Apply the cleansing gel to your face and clean your skin using circular, even movements, to remove
residue, dirt and dead skin cells.
• After this cleansing process, apply a toner as usual, to remove any residue from your skin.
• Pat your skin dry with a towel and then apply a moisturising cream using even, circular movements.
• Switch off the device by pressing the on/off switch once or twice, as applicable.
• To remove the attachment, turn it anticlockwise.

5. Care and storage

WarnInG
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Do not clean the device in the dishwasher.
• For hygiene reasons, you should wash the attachments thoroughly in warm, running water, using a
little cleansing lotion, after every use. Following this, rinse thoroughly with fresh water.
• Wash the base device and the base station with a moist towel. Do not use any cleaning additives
or hard brushes. Clean all parts thoroughly before you pack them away.
• Store the attachments in the storage box supplied for this purpose. Refer to the markings inside
the box for where each should be fixed.
10