Care And Storage; Technical Specifications - Beurer FB21 Mode D'emploi

Masquer les pouces Voir aussi pour FB21:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
Bubble massage, infrared light and maintains water temperature control
• Press the
- button to switch on the bubble massage (with infrared light and maintains water temperature
control).
• Press the
- button to switch the bubble massage (with infrared light and maintains water temperature
control) off again.
These functions are only available together.
Optional vibration massage
While the bubble massage with infrared light and
have the option to switch on the vibration massage. The vibration massage will only function when the
bubble massage with infrared light and
be used separately.
• Press the
- button to activate the vibration massage.
• Press the
- button to switch the vibration massage off again.
Massage roller
You can experience a special massage effect by moving your feet back and forth on the 4 massage
rollers integrated into the bottom of the footbath. The massage rollers can optionally be removed by
pulling them firmly upwards.
Removable attachments
Place the desired attachment on the holder in the centre.
The brush attachment can be used to stimulate the reflex zones in the soles of your feet
The massage attachment provides a soothing massage for your feet and promotes the circulation.
The corn and callus remover is used to remove dead skin cells and calluses.
Note
• Massage of a specific point on the sole of the foot may influence the corresponding organ of
the body. However, we recommend studying relevant literature and asking your doctor before
using point reflex zone massage to achieve the desired effect.
After use pour the water out over the narrow side of the footbath.

8. Care and storage

After use rinse the unit with tap water. The foot bath can be cleaned with a mild, non-foaming house-
hold cleaner, e.g. neutral vinegar. To dry the air lines, switch to the bubble setting without water for
approx. 1 minute.
Note
• Do not allow water to penetrate the interior of the footbath.
• Store the footbath in its original packaging in a dry area.
• Do not leave it open for an extended period.

9. Technical specifications

Supply
Dimension
Weigth
maintains
220-240 V ~ 50-60Hz, 60 W
36.5 x 42.4 x 17 cm
ca. 1.6 kg
water temperature control is running, you
maintains
water temperature control is switched on. It cannot
15

Publicité

Table des Matières
loading

Table des Matières