Timer Function; Led Light Ring; Cleaning And Maintenance; Filter Drying Function - Beurer Lb 300 Plus Mode D'emploi

• With the air humidifier turned on, use the fan speed button
display shows the currently set fan speed or current mode. After a few seconds, the current relative
12
humidity of the room is shown again on the display
Illumi-
nates in Description
display
I Low fan speed
2 Medium fan speed
3 High fan speed
SL
In NIGHT mode, the LED light ring
except for the NIGHT indicator
A In AUTO mode, the fan speed is automatically adjusted depending on how close the
current humidity is to the desired target humidity.

7.4 Timer function

The air humidifier features a timer function that you can use to determine the number of hours the air
humidifier should run for before it automatically switches itself o . You can set a timer for between 1 and
9 hours.
1. Use the timer button
(e. g. 5 h). After a few seconds, the current air humidity is shown again on the display
2. To switch o the timer, press the timer button
is now switched o .

7.5 LED light ring

The LED light ring
2
LED light ring colour
white
blue
switched o
The LED light ring
2
hold the target humidity button

8. CLEANING AND MAINTENANCE

8.1 Filter drying function

Mould and bacteria can form in the filter
the residual water from the tank and dry all parts when the device is not in use. Allow the filter
or use the filter drying function for faster drying:
1. Before activating the filter drying function, ensure that the residual water has been emptied from the
tank (residual moisture may collect under the filter holder
drying function can only be started once the residual water has been emptied.
2. To activate the filter drying function, press and hold the fan speed button
drying indicator
19
setting for the next 3 hours. To switch o the filter drying function prematurely, press any other button.
3. After the time has elapsed, check that the filter
activate the filter drying function again.
to select your desired timer. The currently set timer lights up on the display
15
shows you the current humidity of the room using colours.
Air humidity
≤ 39%
40-70%
can also be switched o or on. To switch the LED light ring
for 5 seconds.
14
5
will start to light up. The filter drying function now dries the filter
.
12
and all displays on the control panel
2
. In NIGHT mode, the low fan speed is always active.
17
repeatedly until 0 h is shown in the display. The timer
15
>70%
when the air humidifier is not in use. Therefore, always empty
, which must be dried manually). The filter
8
is completely dry. If the filter
5
26
to select a fan speed or mode. The
16
Evaluation
Current humidity is too low
Current humidity is OK
Current humidity is too high
o or on, press and
2
for 5 seconds. The filter
16
is not completely dry,
5
go out,
1
12
.
12
to air dry
5
at the highest
5