Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLING THE FAN
1. Insert the pedestal (8) into the hole in the base (9), and then tighten the screws (10) in the
bottom of the base.
2. Release the screw on the rear of the housing (7), insert the housing into the pedestal (8), raise
the housing to the required height, then re-tighten the screw.
3. Position the rear guard (6) on the front of the motor assembly, and secure it with the guard
nut (5).
4. Slide the fan blade (4) onto the motor shaft, and secure it with the fan nut (3).
5. Place the front guard in front of the rear guard, slide the guard clip over both guards, and
tighten the clip to clamp the front and rear guard securely.
Akku 4400 mA/11,1 V
1. Insert the battery into the battery compartment.
2. With the power supply unit connected and the fan in the standby mode, the battery is charged
automatically. The lights flash to indicate charging.
3. While the fan is operating, battery charging will be slower.
4. The rechargeable battery can be used as a power bank via the USB cable.
5. With the power supply unit connected, the fan can also be operated without the rechargeable
battery.
USB Out
Battery compartment
Charge indicator
Charging socket
OPERATION
Make sure the power supply unit is properly inserted into the power outlet, and that the mains
supply voltage is correct. At the same time, a "beep" tone indicates that the fan is in the standby
mode.
Switch buttons
Press
to turn the fan on. The symbol
(6 speeds possible). Press
again to turn the fan off.
Time setting
With the fan switched on, press
to set the timer. The time indicator turns from white to green
color, and all lights are dimmed. The light for operating hours starts flashing.
1 h –> 2 h –> 3 h –> 4 h –> 5 h –> 6 h –> Off
With the fan switched off, press
to save the time setting. The light turns from green to white
color, and it starts to count down when the indicator is dimmed. The light for operating hours
starts flashing. Pressing
will save the fan speed setting.
1 h –> 2 h –> 3 h –> 4 h –> 5 h –> 6 h –> Off
Swing switch
Start oscillation by pressing the
button. Press again to stop oscillation.
Lamp switch
Press
to switch all the indicator lamps off (energy saving mode). In this mode, all functions
work normally, only the lamps are off. Press any button to exit the energy saving mode.
36 37
lights up in green color. Press
to set the fan speed
Publicité
Table des Matières
