Starting A Charge / Discharge Process - ROBBE Power Peak B7 EQ-BID Notice D'utilisation

6.3

StaRtING a ChaRGE / DISChaRGE PROCESS

• Connect charger to power supply, connect battery pack.
• Press the 'EDIT / ENTER' button to call up the battery memory select parameter.
• Enter the battery parameter, then press "EDIT / ENTER" to confirm your choice.
• For safety's sake the saved parameters are displayed again (If
there is an error, connect the values now).
• Pressing the 'MODE' button initiates the selected process (CHARGE, DISCHARGE,
etc.); an audible signal indicates the charger's status. The screen now shows the wor-
king display, which includes all the important parameters (see section 5.2).
• You can alter the current during the process using the "EDIT / ENTER" button and the
'+'- or '-' button; the new value flashes before being adopted.
ExPLaNatION Of ChaRGE MODES
Press "MODE" button once: battery is charged (CHARGE).
Press "MODE" button twice: battery is discharged (DISCHARGED)
Press "MODE" button three times: cycle charge. The charged battery is first discharged,
and then
Press "MODE" button four times: "STORE" mode can be used to bring Lithium batteries
Press "MODE" button five times: triple cycle. The battery is alternately discharged and
Operating Instructions
Power Peak ® B7 EQ-BID
immediately charged again (DISCHARGE>CHARGE).
to a defined voltage for "Winter storage".
For all Lithium batteries the charge is terminated at 60% of the
set battery capacity. The battery parameters should
therefore be set very carefully beforehand.
charged again three times.
13