Setting The Discharge Current; Saving The Settings; Starting A Charge/Discharge Or Store Process - ROBBE POWER PEAK TRIPLE 360 W EQ-BID Notice D'utilisation

POWER PEAK® TRIPLE 360 W EQ-BID

SETTING THE DISCHARGE CURRENT

tery type. The processor in the battery charger limits the maximum discharging current.
SETTING THE AUDIBLE SIGNAL
In this menu, the end of charge process warning sound can be selected. There are 5 sound

SAVING THE SETTINGS

Press the 'INC/ DEC ' button to leaf through the screen display until the arrow is next to

7.4 STARTING A CHARGE/DISCHARGE OR STORE PROCESS

© robbe Modellsport
Operating instructions
The discharge current up to 1A can be selected in
steps of 0.1 A. The maximum discharge current is
dependent on the battery voltage as well as the bat-
styles to choose from, in addition, the sound gene-
rator can also be turned off. Each pressing of the
"INC" or "DEC" button will set a new sound and at
the same time to make the choice easier, will sound
again.
End. The settings are saved by pressing the ENTER
button. The Display shows the start display again, it
returns to its initial home position.
• Press 'MAN', and the Start display appears.
• Press 'ENTER' to prepare the displayed .
memory for the charge process.
• Use the 'MODE' button to select
the desired process
• To make sure, the stored parameters are
displayed once again
• Press the START button to start the charging
process, an acoustic signal indicates the
status. Then the working display,
containing all the important parameters,
is then shown (see Section 5.1).
With the 'INC' or 'DEC' button , you can change
the current during the charging procedure,
the new value flashes before being adopted.
15
Order No.
8562