Setting The Charging Current - ROBBE POWER PEAK TRIPLE 360 W EQ-BID Notice D'utilisation

POWER PEAK® TRIPLE 360 W EQ-BID
The following voltages are available to use for lithium batteries:
Cell count
1
2
3
4
5
6
ENTERING THE BATTERy CAPACITy
as the basis for the 1C charge, i.e. the charging current is automatically set to the corres-
ponding 1C charge of the battery. It additionally serves as a battery safety function.
Battery type
NiCd
NiMH
LiPo
LiIo
LiFe
Pb (lead)

SETTING THE CHARGING CURRENT

charger limits the maximum charging current if the maximum charging capacity is excee-
ded.
© robbe Modellsport
Operating instructions
Alternatively, the battery voltage can be selected in
2V-steps per cell for lead battery packs.
Battery voltage
2 Volt
4 Volt
6 Volt
8 Volt
10 Volt
12 Volt
In this menu, battery capacity can be selected in
steps of 100 mAh (PB, 500 mAh). The battery capa-
city setting for lithium battery packs mainly serves
Battery capacity
100 - 9900 mAh
100 - 9900 mAh
100 - 9900 mAh
100 - 9900 mAh
100 - 9900 mAh
0.50 Ah - 20.00 Ah
The charging current up to 10A can be selected in
steps of 0.1 A. The maximum charging current is
dependent on the number of cells or the battery vol-
tage and the maximum charging capacity (max. 2C
for lithium batteries). The processor in the battery
14
The range of capacities shown in the
table here are available and depend
upon the type of battery:
Order No.
8562