End Of A Charge / Discharge Process; Display Of The Charge / Discharge Data - ROBBE POWER PEAK TRIPLE 360 W EQ-BID Notice D'utilisation

POWER PEAK® TRIPLE 360 W EQ-BID
ted, please refer to chapter 11 „BATTERY ID INCOMPATIBILITY". The further procedure
is identical to that used for a manual start. This procedure is described in Section 7.4.
Following a charge or discharge cycle, the most important data is stored on the chip/key.
10.

END OF A CHARGE / DISCHARGE PROCESS

The charger automatically finishes a charging or discharging operation precisely at the
correct time. The processor takes into account the charging parameters. The optimum
process is used for each type of battery.

10.1 DISPLAy OF THE CHARGE / DISCHARGE DATA

During a charge or discharge process, the values for that process are constantly shown
Charged-in
Status display
or discharged
flashing 'F' (finish)
capacity
Actual battery
voltage
Battery type
© robbe Modellsport
Operating instructions
First connect the BID chip/key via the adapter lead
or directly to the charger. This now automatically
causes the screen display shown here to appear.
To set up the charging parameters, press the
ENTER button. Thereafter, the charging mode (char-
ge, discharge or ENTL-charge) can be adjusted with
"DEC" button. In case the battery type N/A is indica-
in the working display (see Chapter 5.1).
Elapsed char-
ge / discharge
An audible signal will be heard upon suc-
time
cessful conclusion of the charging process.
As shown in the illustration opposite, the
most important data are shown in the
display.
Charge /
discharge
current
19
Order No.
8562