ROBBE POWER PEAK TRIPLE 360 W EQ-BID Notice D'utilisation page 37

POWER PEAK® TRIPLE 360 W EQ-BID
ExPLAINING STORE MODE (JUST FOR LITHIUM BATTERy)
Just like setting up the charge, discharge or cycle modes, select "STORAGE PROGRAM" via
the "MODE" button. With this mode, Lithium batteries can be "winterised" and maintained at
a preset voltage. The battery parameters should be carefully set up.
The cut-off voltage has been set as follows:
LiPo: approx.. 3.85 V / cell
LiFe: approx. 3.45 V / cell
LiIo: approx. 3.75 V / cell
Depending upon the voltage state of the battery connected, it will be automatically charged
or discharged until the cut-off voltage has been achieved.
Note: For safety reasons, one should always connect the battery voltage sensor lead
to the charger!
SELECTING A MEMORy LOCATION
SELECTING THE TyPE OF BATTERy
SETTING UP NUMBER OF CELLS/BATTERy VOLTAGE
The following voltages are available to use for lithium batteries:
LiPo
Cell count Battery voltage
1 3,7 Volt
2 7.4 Volt
3 11.1 Volt
4 14,8 Volt
5 18,5 Volt
6 22,2 Volt
© robbe Modellsport
Operating instructions
Selecting a memory position between 0 and 9.
The battery types NiCd, NiMH, LiPo, LiIo, LiFe or PB
(lead) can be selected in this menu.
Here the number of cells can only be selected bet-
ween 1 and 14 cells for NC and NiMH battery packs.
With the battery types LiPo, LiIo, LiFe and Pb (lead-
acid) you should enter the nominal battery voltage
instead of the cell count.
LiIo
Cell count Battery voltage
1 3,6 Volt
2 7,2 Volt
3 10,8 Volt
4 14,4 Volt
5 18,0 Volt
6 21,6 Volt
13
Order No.
8562
LiFe
Cell count Battery voltage
1 3,3 Volt
2 6.6 Volt
3 9,9 Volt
4 13,2 Volt
5 16,5 Volt
6 19.8 Volt