ROBBE Power Peak B7 EQ-BID Notice D'utilisation page 49

11. SafEty NOtES
• Check for damage to the casing and leads.
• Take particular care when handling battery packs with a large number of cells. Ensure
good insulation to prevent the risk of electric shock.
• Never Never use the charger close to inflammable materials or gases.
• Never open the device when connected to a live power source!
• Do not leave the charger unattended during operation. The charger can heat up consi-
derably during normal operation.
• The Power Peak® B7 EQ-BID is designed for charging, discharging and equalizing
rechargeable NC / NiMH / lead-acid and lithium batteries only. Never attempt to recharge
dry cells, as they might explode.
• The charger is designed for operation with a 12 V DC source and 230 V AC power sup-
ply unit. Never operate the charger on a different voltage.
• Protect the charger from dust, dirt and moisture.
• Do not expose the charger to excessively low or high temperatures or direct sunlight.
• Avoid subjecting the unit to shock and pressure, and do not expose it to severe vibra-
tion.
• Ensure the cooling vents are always clear to allow air to circulate freely.
• Do not operate the charger while in its case!
• When not used for a long period of time, unplug the charger from the power source and
disconnect any batteries.
• Do not charge rechargeable batteries twice in quick succession.
• Do not charge batteries that are at a high temperature. Allow batteries to cool down to
ambient temperature.
• Only cells of the same capacity and of the same make may be charged together.
• Never charge two batteries connected in parallel to one output. Connect only one
rechargeable battery pack at a time.
• Ensure correct polarity of the battery and avoid short-circuits.
Observe the instructions provided by the battery manufacturer.
• Always take great care to check the settings on the Power Peak® B7 EQ-BID. Bat-
teries can be ruined if the settings are incorrect.
Operating Instructions
Power Peak ® B7 EQ-BID
21