Generalinformation; Unpacking; Accessories Included; Assembly - Generac Gp Serie Manuel De L'utilisateur

1.1 UNPACKING
* Removeall packagingmaterial.
. Removeseparateaccessory box.
. Removethe generatorfrom carton.
1.1.1 ACCESSORIES I NCLUDED
* 1-Owner's manual
* 1-Bottle of Oil SAE 30
* 3-Product RegistrationCards (English,Spanish, French)
* 1-Battery Charger(electric start only)
* 1-HandleAssembly (attachedto bottom of frame)
* 1- Hex head bolt (A) (attachedto frame at handle assembly)
* 1-Acorn Nut (B) (attachedto frame at handle assembly)
* 1-Foot Assembly (E) [includes 4-Flanged Nuts (C), 2-Rubber
Feet(U), 2-Short Bolts (F)]
. 2-Axle Pins (G)
* 2-Never-FlatWheels (H)
* 2-Washers(I)
* 2-Cotter Pins (J)
1.2 ASSEMBLY
The generator requires some assembly prior to using it. If
problems arise when assembling the generator, please call the
GeneratorHetplineat 1-888-436-3722.
1.2.1 ASSEMBLING THEACCESSORY K IT
Referto the instructionsbelow and Figures1,2, and 3 to install the
handle,foot, and wheels. Note:The handle and foot components
are already pre-assembled from the factory. The wheels are
designedto greatly improve the portability of the generator.You
will needthe following tools to properly install the accessory kit:
• Socketwrench
• Foot: lOmm socket, 13mm wrench or socket
• Handle: 13mm and 14mm sockets or wrenches
• Wheels: Pliers
Handle
1. Installthe handleassemblyto the frame by usingbolts (A) and
nuts (B).
Foot
2. Mount the foot assembly (E) to the frame with two bolts (F)
and nuts (C).
Wheels
3. Slide axle pin (G) through wheel (H), washer (I), and through
the bracket on the frame.
4. Secureaxle pin (G) to the frame with the cotter pin (J).
5. Use a pliers and bend one tab of cotter pin (J) outward to lock
into place.
6. Repeatsteps 4, 5, & 6 for other wheel.
Figure 1 - Handle Assembly
®
Figure 2 - Foot Assembly
\
]
\
°