Charging Process - Ingeteam INGEREV RAPID 50 Trio Manuel D'installation Et Usage

Ingeteam
If there is a warning it will be displayed as follows:
19:30
CCS
22.2 kW
0.4 kWh
371 V
60 A
K. Communication error. The station has lost the
connection with the Internet or with the central
manager.

11.2. Charging process

The charging process is described below.
1. Where charging is already taking place at the station, the first step consists of adding a vehicle using the
display (otherwise, this step is not necessary). The charging station can perform two charging processes at
once: AC and CCS or AC and CHAdeMO. Simultaneous CCS and CHAdeMO charging is not possible. Press
the following icon:
2. Select the socket required according to the equipment characteristics. The available sockets will be
displayed on the screen.
3. User identification by card is then requested. Place the card near the reader located at the bottom of the
display.
4. Details of the applicable rates are shown.
5. Connect the vehicle to the charging station.
6. The charging process starts.
7. Once charging is complete, press End and follow the process indicated on the display.
36
Charging
56%
L. Exception in the indicated charge session. In
this case it is indicating an incident in charge
session number 2.
ABT2012IQM01_B- Installation and Operation Manual
Using the unit
EN
K
End
L