Haier AB052MCERA Manuel D'instructions page 20

Installation Procedures
Situation with Original Ceiling
(1) Install the indoor unit temporarily: attach the
hoisting foot to hoisting stud. Make sure that
nuts and washers (provided on site) should be
used at two ends of the foot to secure the foot.
(2) Adjust the height and location of the unit.
(3) Perform Step 4 and 5 in Situation with New
Ceiling.
Preparation of Decorated Board
Don t put the decorated board downward to the floor. Putting it against the wall or on the
extrusive objects is not allowed.
Don t touch the wind deflector or apply force on it, or the wind deflector will have faults.
(1) Check if the indoor unit is in the horizontal level with the water level and the polythene tube
with water and check if the size of the ceiling hole is correct. Take away the water level before
mounting the decorated board.
(2) Fasten the screw to make the height difference between two sides
of the indoor unit less than 5mm.
Installing the decorated board on the body of indoor unit:
Limits when mounting the board: mount the board as shown in the figure. Incorrect direction
may cause air leakage, and meanwhile the swinging and receiving displays can t be connected.
Position it with screws temporarily first.
Screw the two positioning screws and the other 2 screws and fasten them.
Connect it to the motor line, communication line and power line, and check with the controller
if the connections are correct. Mount air inlet grid and corner covers after making sure that
the machine can operate normally.
receiving window
for remote control
the lamp will not flash when
wired controller is used
nut (provided on site)
washer
hoisting foot
tightening (dual nuts)
secure hoisting foot
12
washer
secure washer foot