Haier AB052MCERA Manuel D'instructions page 17

Installation Procedures
The standard attached accessories of the units of this series refer to the packing list; prepare
other accessories according to the requirements of the local installation point of our company.
Indoor units should be installed in places with the environment of even circulation of cool and
warm blows. The following places should be avoided.
places with high salinity (beach), high sulfureted gas(such as the thermal spring regions where
copper tubes and soft soldering are easy to be eroded), much oil(including mechanical oil) and
steam; places where organic substance solvent is used; where special spray is frequently used;
places where machines generate the high frequency electromagnetic wave (abnormal condition
will appear in the control system);
places where there is high humidity exists near the door or windows (dew is easily formed).
Warning: protect the machine from gales or earthquake, make the installation according to
the regulations. Improper installation will cause accidents due to the overturn of the air
conditioner.
Select the following places to install indoor units.
(1) where there is enough room for the machine above the ceiling;
(2) where the drainpipes can be well arranged;
(3) where the distance between the air outlet port of the machine and the floor is not more than
2.7m;
(4) where air inlet & outlet of the indoor units are not blocked;
(5) where it is hard enough to bear the weight of the unit;
(6) where there are no television, piano and other valuables under the indoor units as to avoid
condensate dropping down, causing damage.
(7) Where it is over 1m away from the television and radio as to avoid the disturbance from
television and radio.
Installation Space
Ensure the required space for installation and maintenance (refer to the following drawings).
The installation height should be kept within 2.7m.
When the height of the ceiling exceeds 2.7m, the warm air is hard to blow to the ground.
outlet inlet
1500mm
over 2500mm
outlet
1500mm
9
model
AB052~162MCERA
AB182MCERA(C)
AB182~282MCERA
AB302~482MCERA
A(mm)
320
280
335