Factory Set Comfort & Reduced Temperature Times In Programs P1 - P9 - Selfio FlowBox-HC Guide D'installation Et D'utilisation

the programmed values for day 1 are stored. Programming other days is done using identical procedure
moving the cursor by pressing (►). When you switch over to programming the next day the program for the
previous day is saved. On completing the programming of the last day 7, the indication first switches to the
program menu
If during programming no inputs are made within 20 seconds, indication switches first to the program menu
, and in another 15 seconds it returns to
Factory / built-in programs (P1 – P9)
If you select any of the factory programs from P1 to P9, you confirm it by pressing the key (ОК). Then
pressing the arrow key (◄) scroll back to the menu for selecting an operation mode (if the arrow key is not
pressed in about 15 seconds the display turns back to operating mode
6.2.1 Factory set COMFORT & REDUCED temperature times in programs P1 - P9
P1: Morning, Evening & Week-end
P2: Morning, Midday, Evening & Week-end
P3: Day & Week-end
P4: Evening & Week-end
P5: Morning, Evening (bathroom)
The ClimaticControl-HC program operates only in
DUCED temperature periods.
, and in about 15 seconds back to .
. The inputs were not stored.
P6: Morning, Afternoon & Week-end
P7: 7h - 19h (Office)
P8: 8h – 19h , Saturday (Shop)
P9: Week-end (Secondary House)
mode according to the selected COMFORT and RE-
15
).
GB