Safety Regulations - Ariston FWS Installation Et Mode D'emploi

safety regulations

Safety regulations
Symbol legend:
Failure to comply with this warning implies the risk of per-
sonal injury, which in some circumstances may even be fatal.
Failure to comply with this warning implies the risk of po-
tentially serious damage to objects and plants or harm to
animals.
Install the device on a solid wall that is not subject to
vibrations.
Noise during operation.
When drilling the wall, take care not to damage any elec-
trical wiring or existing piping.
Electrocution caused by exposure to live wires. Explosions,
fi re or intoxication due to gas leaks from damaged pipes.
Damage to existing plants. Flooding due to water leaking
from damaged pipes.
Perform all electrical connections using suitably-sized
conductors.
Fire caused by overheating due to electrical current passing
through undersized cables.
Protect connection piping and cables so as to prevent
damages to them.
Electrocution caused by exposure to live wires. Explosions,
fi re or intoxication due to gas leaks from damaged pipes.
Flooding due to water leaking from damaged pipes.
Make sure the installation site and any systems to which
the device must be connected comply with the applica-
ble regulations.
Electrocution caused by contact with live wires that have
been incorrectly installed. Damage to the device caused by
improper operating conditions.
Use manual tools and equipment that are suitable for
the intended use (in particular, ensure that the tool
is not worn and that the handle is intact and securely
fi xed); use them correctly and prevent them falling from
a height. Put them safely back in place after use.
Personal injury caused by fl ying splinters or fragments, inhala-
tion of dust, knocks, cuts, puncture wounds and abrasions.
Damage to the device or surrounding objects caused by fl y-
ing splinters, knocks and incisions.
Use suitable electrical equipment (in particular, make
sure that the power supply cable and plug are in good
condition and that the rotating or moving parts are
properly attached); use the equipment correctly, do not
obstruct passageways with the power supply cable and
ensure that no equipment runs the risk of falling from a
height. Disconnect the equipment and put it safely back
in place after use.
Personal injury caused by fl ying splinters or fragments, inhala-
tion of dust, knocks, cuts, puncture wounds, abrasions, noise
and vibration. Damage to the device or surrounding objects
caused by fl ying splinters, knocks and incisions.
Make sure that any portable ladders are securely posi-
tioned, that they are suffi ciently resistant, that the steps
are intact and not slippery, that the ladders are not
moved with someone on them and that someone super-
vises at all times.
Personal injury caused by falling from heights or shearing
(stepladders shutting accidentally).
Make sure that any rolling ladders are positioned securely,
that they are suitably sturdy, that the steps are intact and
not slippery. Make sure that the ladders are fi tted with
handrails on either side of the ladder and parapets on the
landing.
Personal injury caused by falling from a height.
During all work carried out at heights (generally above
two metres), make sure that parapets are used to sur-
round the work area or that individual harnesses are used
to prevent falls. The space where any accidental fall may
occur should be free from dangerous obstacles, and cov-
ered by semi-rigid or deformable surfaces for cushioning.
Personal injury caused by falling from a height.
Make sure that the work area has adequate hygiene and
health conditions in terms of lighting, ventilation and
the solidity of relevant structures.
Personal injury caused by knocks, stumbling, etc.
Protect the device and all areas in the vicinity of the work
area using suitable material.
Damage to the device or surrounding objects caused by fl y-
ing splinters, knocks and incisions.
Handle the device with care, while using suitable protec-
tion equipment.
Damage to the device or surrounding objects caused by
shocks, knocks, incisions and crushing.
During all work procedures, wear individual protective
clothing and equipment.
Personal injury caused by electrocution, fl ying splinters or
fragments, inhalation of dust, shocks, cuts, puncture wounds,
abrasions, noise and vibration.
Arrange materials and equipment in such a way as to
make handling easy and safe, and avoid forming any
piles which could give way or collapse.
Damage to the device or surrounding objects caused by
shocks, knocks, incisions and crushing.
All operations inside the device must be performed with
the necessary caution in order to avoid sudden contact
with sharp parts.
Personal injury caused by cuts, puncture wounds and abra-
sions.
Reset all safety and control functions aff ected by any
work performed on the device and make sure that they
operate correctly before restarting the device.
Explosions, fi res or intoxication caused by gas leaks or incor-
rect fl ue gas discharge. Damage or shutdown of the device
caused by out-of-control operation.
Before handling, empty all components which may con-
tain hot water and perform bleeding where necessary.
Personal injury caused by burns.
Descale the components, in accordance with the instruc-
tions provided on the safety data sheet of the product
used, while ventilating the room and wearing protective
clothing; avoid mixing diff erent products and protect
the device and surrounding objects.
Personal injury caused by acidic substances coming into
contact with skin or eyes, inhaling or swallowing of harmful
chemical agents. Damage to the device or surrounding ob-
jects due to corrosion caused by acidic substances.
If you smell burning or see smoke coming out of the de-
vice, disconnect it from the power supply, open all win-
dows and contact the technician.
Personal injury caused by burns, smoke inhalation, intoxica-
tion.
GB
23