Interface Cover Installation - Keysight Rp7970 Serie Manuel D'utilisation

Interface Cover Installation

The ESD cover and hardware are shipped with the unit (see
1. Connect the cover flange to the side of the instrument using the two screws provided. IMPORTANT
- This must be done before rack mounting the unit.
2. Connect the LAN, USB, GPIB cable, and digital IO wires (GPIB shown) to the appropriate rear panel
connector.
3. Insert the cover tabs into the flange. Attach the ESD cover to the back of the unit using the two cap-
tive cover screws.
Keysight RP7970 & RP7980 Series Operating and Service Guide
2 Installing the Instrument
Items Supplied).
81