Clear Output Protection - Keysight Rp7970 Serie Manuel D'utilisation

Masquer les pouces Voir aussi pour RP7970 Serie:

Table des Matières

Les langues disponibles

4 Using the Regenerative Power System

Clear Output Protection

If an over-voltage, over-current, over-temperature, power-fail, power-limit, inhibit, or any other

protection condition occurs, the output is disconnected into a high-impedance state. The appropriate

operating status indicator on the front panel will be on. To clear the protection function and restore

normal operation, first remove that condition that caused the protection fault. Then, clear the

protection function as follows:

Front Panel Menu Reference

Select Protect\Clear

Select Clear.

The output is re-enabled once the output protection function is cleared.

SCPI Command

To clear a protection fault:

OUTP:PROT:CLE

Keysight RP7970 & RP7980 Series Operating and Service Guide

Table des Matières