DeWalt D55154 Guide D'utilisation page 10

English
Fig. K 22
21
Moving
1. Grasp handle 15 of compressor and pull up until it
stops. Turn knobs to lock handle in place.
2. Grasp handle and tilt compressor so unit can be rolled
on the tires.

WARNING: Risk of unsafe operation. Ensure proper
footing and use caution when rolling compressor so
that unit does not tip or cause loss of balance.
3. When location is reached slowly lower compressor
to ground. Always store compressor in a
horizontal position.
nOTE: Should the unit tip over, hard starting and smoking
will occur due to oil spillage.
Dolly Feature
1. Grasp handle of compressor and pull up
15
until it stops. Turn knobs to lock handle in place.
iMPORTAnT: Always pull handle up and lock in place
before using as a dolly.
Fig. L
2. Place cargo onto top panel of compressor.
3. Secure cargo to top panel with retention straps. Hook
cargo retention straps into positioning holes in top
panel. nOTE: Retention straps to secure cargo may be
purchase from a local hardware store or home center in
a variety of sizes.
Fig. M
8
15

CAUTION: Risk of unsafe operation. Do not transport
unsecured cargo.

CAUTION: Risk of unsafe operation. Load limit is
100 lbs. (45.4 kg) do not exceed.
4. With cargo secured, grasp handle and tilt compressor so
unit can be rolled on the tires.

WARNING: Risk of unsafe operation. Ensure proper
footing and use caution when rolling compressor so
that unit does not tip or cause loss of balance.
5. When location is reached slowly lower compressor
to ground. Always store compressor in a
horizontal position.
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Preparation For Use
Pre-Start Checklist (Fig. A)
1. Ensure the On/Off switch
2. Plug the power cord into the correct branch circuit
receptacle. See Voltage and Circuit Protection
under Assembly and Adjustments.
3. Ensure air tank is drained, see Draining Air Tank
under Maintenance.
4. Ensure the drain valve 8
5. Ensure safety valve 7 is functioning properly, see
Checking safety Valve under Maintenance.
6. Check pump oil level, see Compressor Pump Oil
under Maintenance.

CAUTION: Do not operate without oil or with
inadequate oil. D WALT is not responsible for
e
compressor failure caused by inadequate oil.
7. Turn regulator knob 4 counterclockwise until fully
closed. Ensure regulated pressure gauge reads 0 PSI
(0 kPa).
8. Attach hose and accessories.

WARNING: Risk of unsafe operation. Firmly grasp
hose in hand when installing or disconnecting to
prevent hose whip.
9. Ensure all covers and labels are in place, legible (for
labels) and securely mounted. Do not use compressor
until all items have been verified.

WARNING: Risk of bursting. Too much air pressure
causes a hazardous risk of bursting. Check the
manufacturer's maximum pressure rating for air tools
and accessories. The regulator outlet pressure must
never exceed the maximum pressure rating.
Initial Set-up (Fig. A)

WARNING: Do not operate this unit until you read
and understand this instruction manual for safety,
operation and maintenance instructions.
1 is in the OFF position.
is closed.