Power Supply - Sony WRR-862A Mode D'emploi

Parts Identification
0 + (+ selection) / – (– selection/reset) buttons
When setting the transmission channel, frequency, squelch
level and backlight mode, press these buttons to change its
contents. The "–" button resets the accumulated time
indication to "00:00".
qa SET button
Press to set and fix the item on the display.
qs MODE button
Press to select the item shown on the display.
qd CONTROL switch
Select the tuner to be set.
qf POWER switch
Turns the power of the tuner ON or OFF.
qg DC 12V IN connector
For external power operation, connect to an external power
supply (DC 10 V to 17 V) of a camcorder using the supplied
power cable.
For connecting the antennas, output cables and DC power
cable and attaching the unit to a camcorder, see
"Appendix" on page 15.
6
(GB)

Power Supply

Installing the batteries
The tuner can operate on four LR6 (size AA) alkaline
batteries continuously for about 5 hours at 25°C (77 °F).
Four Alkaline batteries LR6 (sizeAA)
1
Slide the battery-holder catches inward to take out the
battery holder.
2
Match the polarities and insert the batteries.
3
Set the battery holder in the original position.
Confirm that both catches on the holder are locked.
Battery indication
When you turn the power on, the battery status of this unit
appears in the BATT indication on the display section.
Note
The indication may be incorrect if the batteries are not new
when installed. If you plan to use the tuner for a long
period, it is best to replace the batteries with new ones.