Helios AIR1 XC 500 L Notice De Montage Et D'entretien page 68

Installation and Operating Instructions
EN
m
DANGER
m
DANGER
m
DANGER
m
CAUTION
ATTENTION
m
DANGER
Compact Ventilation Units AIR1 XC
The maximum permissible stack quantity for the units can be seen in the following table:
Unit type Stack quantity
AIR1 XC 500 4 pcs.
AIR1 XC 700 4 pcs.
AIR1 XC 1400 3 pcs.
AIR1 XC 2200 3 pcs.
AIR1 XC 3200 3 pcs.
2�1�3 Shipping
The shipping must be carried out carefully. The unit is packed ex works in a timber frame so that it is protected against
normal transport strain. It is recommended to leave the unit in the original packaging until installation to avoid possible
damages and contamination.
The shipping must be carried out by trained and experienced personnel and the necessary safety precautions should
be taken to prevent overturning and slipping of the device. it should be ensured that the weight is evenly distributed
over the four corners when shipping the unit.
m
Personal injury and/or material damage due to incorrect shipping!
It must be ensured that the means of transport/lifting is suitable to accommodate to the required weight and size
capacity.
– Never stand beneath suspended loads.
– Make sure that the unit is firmly seated before lifting it.
m
Danger due to overhead loads!
Lifting gear, units, cables or tackle could be faulty or damaged.
– Never stand beneath suspended loads.
– Make sure that the unit is firmly seated before lifting it.
m
Personal injury and/or material damage due to unit tipping over!
Due to the high centre of gravity, the unit can tip over and cause personal injury and material damage.
– When transporting the unit, carefully observe its behaviour and stay clear of any possible hazardous areas.
m
Risk of injury from protruding nails!
– Wear protective gloves.
– Look out for nails when dismantling the timber frame!
Package dimensions and weights
The dimensions and weight of the individual unit types are shown in the following table:
Unit type Package dimensions
W x B x D (mm)
558 x 1778 x 1188
AIR1 XC 500
AIR1 XC 700 561 x 1794 x 1363
AIR1 XC 1400 601 x 1919 x 1663
AIR1 XC 2200 684 x 2144 x 2081
AIR1 XC 3200 771 x 2290 x 2331
Material damage due to excessive load!
Before off-loading the units, please ensure that the means of transport/lifting have sufficient capacity for the required
weight.
m
Personal injury and/or material damage due to the unit falling from the forklift!
Before transporting the unit, please ensure that the forks of forklift truck are long enough to lift more than the entire
underside of the unit (see Fig. 2).
The unit can be transported using a forklift, pallet truck or crane.
– Lift the unit from the attached brackets at the corners of the packaging.
– Ensure a symmetrical load distribution before lifting the unit.
Package weight
(kg)
170
200
270
360
440
5
Fig� 3