Télécharger Imprimer la page

Blodgett Combi BLCP-61G Manuel D'installation page 54

Publicité

Les langues disponibles

Les langues disponibles

5. If the cavity temperature is above 175_F
(80_C), the oven will automatically enter cool
down. When the cavity is below 175_F (80_C)
the CombiWash cycle begins.
6. The control counts down the time remaining
in the wash cycle.
7. When the wash cycle is over, the oven auto
matically switches to an energy saving stand
by mode.
In addition to the daily cleaning, it is necessasry to
clean the control filter and behind the fan guard on
a weekly basis. This is necessary for proper func
tioning of the oven. Scale will build up on the fan
and heat source leading to a less efficient oven.
The control filter is located below the control
compartment, in front of the spray hose.
1. To remove, pull down on the black knob on the
left of the filter.
2. Clean the filter with soap and water.
3. Reinstall the filter. Press up on the filter until the
back of the knob is inserted into the hole in the
bottom of the oven.
4. Push up on the center of the knob to expand
the back of the knob securing the filter.
1. Loosen the two screws and on the fan guard
(or baffle).
2. Swing the baffle forward.
3. Thoroughly spray cleaner onto the fan and
heat source. Place the oven in the steam
mode for approximately 10 minutes.
4. After ten minutes, rinse the cleaner off. Return
the fan guard to the closed position. Rotate
the two screws to secure the fan guard.
The best preventive maintenance measures are
the proper initial installation of the equipment and
a program for cleaning the appliance routinely.
The Oven/Steamer requires no lubrication. Con
tact the factory, the factory representative or a lo
cal Blodgett Combi service company to perform
maintenance and repairs should they be required.
50

Publicité

loading