8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
9. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor (garage or cellar) al-
so, but for optimum performance install
this appliance at a location where the am-
bient temperature corresponds to the cli-
mate class indicated on the rating plate of
the appliance:
Cli-
mate
class
SN
N
ST
T
10. NOISES
There are some sounds during normal
running (compressor, refrigerant circula-
tion).
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter.
8.3 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
"Installation".
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
9.2 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
contact for this purpose. If the domestic
power supply socket is not earthed, con-
nect the appliance to a separate earth in
compliance with current regulations, con-
sulting a qualified electrician.
The manufacturer declines all responsibili-
ty if the above safety precautions are not
observed.
This appliance complies with the E.E.C.
Directives.
ENGLISH
13