Closing The Door; Replacing The Lamp; Installation - Electrolux ENN2801EOW Notice D'utilisation

Problem
All the temperature setting
LEDs flash at the same
time.
If the advice does not lead to
the desired result, call the
nearest brand-mark service.

7.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your After Sales
Service.

8. INSTALLATION

8.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
SN
All manuals and user guides at all-guides.com
Possible cause
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
The FastFreeze function is
switched on.
There is no cold air circu-
lation in the appliance.
An error has occurred in
measuring the tempera-
ture.
Ambient temperature
+10°C to + 32°C
Solution
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Refer to "FastFreeze func-
tion".
Make sure that there is cold
air circulation in the appli-
ance.
Contact the nearest Author-
ized Service Centre. The
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible.

7.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the After Sales
Service.
Climate Ambient temperature
class
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
ENGLISH 13