Adding More Ingredients; Cleaning And Maintenance - Bosch MUZ45MX1 Mode D'emploi

en Use
Use
W Risk of injury
– Before attaching or removing the
accessory, wait until the drive has come
to a standstill and pull out the mains
plug.
– Never reach into the attached blender!
– Never use the blender without the lid in
place.
W Risk of scalding
When you process hot ingredients in the
jug, steam will escape through the filling
opening in the lid.
X Image sequence C (MUM5)
X Image sequence D (MUM4)
1. Only prepare the base unit as described
in the main operating instructions.
Remove the blender drive cover.
2. Position the blender as shown on the
drive. Observe the marking (,) when
doing so.
3. Rotate the blender anticlockwise to the
stop (;).
4. Prepare your food and add to the
blender jug.
5. Attach the lid. Insert the locking cap and
rotate clockwise.
6. Insert the mains plug. Turn the rotary
switch to the recommended setting.
7. Leave switched on until the required
consistency is achieved.
8. Set the rotary switch to f. Wait
until the drive comes to a standstill.
Disconnect the mains plug.
■ Rotate the blender clockwise and
remove.
■ Clean all parts directly after use.
X "Cleaning and maintenance" see
page 10
10

Adding more ingredients

More ingredients can also be added during
processing. The locking cap can be used
here as a measuring jug.
X Fig. E
■ While the appliance is running, remove
the locking cap and carefully add more
ingredients through the filling opening in
the lid.
W Risk of injury!
Do not insert any objects (e.g. knives,
spoons) in the filling opening in the lid.
Never remove the lid while the appliance is
running!
X Image sequence F
1. To add large quantities or ingredients,
turn the rotary switch to f and wait
for the machine to come to a standstill.
W Risk of injury!
Before removing the lid, check the drive
has come to a standstill. Never switch on
without the lid!
2. Remove the lid.
3. Add the extra ingredients.
■ Put the lid with the locking cap back
in place. Continue processing your
ingredients.

Cleaning and maintenance

The accessories used must be thoroughly
cleaned after each use.
W Risk of injury
Do not reach into the blender knife. Grip the
blade insert by the plastic only.
Caution!
– Do not use cleaning agents containing
alcohol or spirits.
– Do not use any sharp, pointed or metal
objects.
– Do not use abrasive cloths or c leaning
agents.
– Do not leave the blade holder or blade
insert in water.
– Do not wedge plastic parts in the
dishwasher as they could become
permanently deformed.