Vetus DBPPJA Mode D'emploi Destiné Au Propriétaire page 10

ENGLISH
1 6 Configuring thrust direction
Carry out the following actions on one panel in the order indica-
ted:
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first press the "ON / OFF" button once to switch the
panel to the OFF position. (see 1.3)
1
10 seconds
1 Place the panel in configuration mode
• Press and hold the "ON / OFF" button for 10 seconds.
2
2 x
2. Press the On/Off button
twice.
4. Configuring thrust
direction for a
bow thruster:
Move the joystick to the
upper left corner and
back until LEDs (1) (blue),
(3) (red) and (4) (green)
flash.
Repeat if necessary.
OR
5. Configuring thrust
direction for a
stern thruster:
Move the joystick to the
bottom left corner and
back until LEDs (1) (blue),
(2) (red) and (5) (green)
flash.
Repeat if necessary.
10
020813.01
dididididididid ( . . . . . . )
6 seconds
(1) BLUE, ashing
3
2
didahdi ( . − . )
4
3. LEDs (1) (blue) (2) (red) and (4) (red) flash and you hear the signal, di-dah-di (. -.)
Now the panel is in configuration mode.
4
4
5
4 seconds
During the first 6 seconds, LED (1) flashes blue and the buzzer will
continuously signal a didididididi ..... (. . . .). Keep pressing the "ON /
OFF" button. After 10 seconds the buzzer sounds the signal didididi-
dah (. . . - -).
1
1 BLUE, ashing
2 RED, ashing
4 RED, ashing
1
1 BLUE, ashing
3 RED, ashing
4 GREEN, ashing
1
1 BLUE, ashing
2
2 RED, ashing
5 GREEN, ashing
5
vetus® Owner's manual DBPPJA - Proportional panel for bow and stern thruster
OR
1
2
ON/OFF
4
dididididah ( . . . . − )
Con guration mode
i
mportant
If another combination of LEDs
is lit, first restore the factory
settings (see 1 5) and start chec-
king the thrust direction again
(see 1 4)
6
6. Press the "ON / OFF"
button once to confirm
the setting.
5
1 x