LawnMaster MEB1016M R Guide D'utilisation page 21

MAINTENANCE
WARNING
Alway s protect hands by wearing heavy gloves and/or wrapping the cutting edges of the blade with
rags and other material when performing blade maintenance. Failure to heed this warning could
result in serious personal inj ury .
WARNING
Before performing any maintenance, make sure the mower is unplugged from the power supply .
Failure to heed this warning could result in serious personal inj ury .
REPLACING THE CUTTING BLADE (See Figs. 19-20)
NOTE: Only use identical replacement blades.
■ Stop the motor and disconnect the power supply. Allow the blade to come to a complete stop.
■ Turn the mower on its side.
■ Wedge a block of wood between the blade and the mower deck in order to prevent the blade
from turning when the nut is being removed.
■ Loosen the blade nut using a 14 mm wrench or soc et (not provided).
■ Remove the blade nut, and blade.
■ Ma e certain the fan assembly is pushed completely against the motor shaft.
■ Place the new blade on the shaft against the fan assembly . Make sure it is installed with the curved
ends pointing up toward the mower deck and not down toward the ground.
■ Thread the blade nut on the shaft and finger tighten.
NOTE: Make certain all parts are replaced in the exact order in which they were removed.
■ Torque the blade nut down using a torque wrench (not provided) to ensure the bolt is properly
tightened.
NOTE: Only use LawnMaster replacement parts. LawnMaster mower blade replacement part # MEB1016M
WOOD BLOCK
Fig. 19
BLADE
BOLT
Fig. 20
21