Maintenance - Tineco FLOOR ONE S3 Série Mode D'emploi

Maintenance

Note:
• For optimal performance and to prevent odors, always clean and dry DWT, floater, filters, brush
roller, brush roller cover completely after each use.
• Please make sure each part is installed correctly or the appliance may not work properly.
• After maintenance, place the appliance on the charging base vertically. Do not expose the appliance
to direct sunlight, and store it indoors in a dry place.
Main Body
To reduce the risk of injury, switch off before
performing maintenance.
When LED loop blinking red, remove Dirty Water
Tank, clean the dirt sensor with a damp cloth or
3-in-1 cleaning tool.
Use a cloth to clean the surface with a neutral
detergent. The cloth should be dry to prevent
water from entering the appliance.
Blinking red
16