Charging Time; Maintenance - Tineco iFLOOR 3 Serie Mode D'emploi

Warning:
• Only charge the appliance with the adaptor
supplied by Tineco.
• During long periods of not being used, the
appliance must be charged once every
3 months for optimal performance. It may take
4-5 hours for a full charge.
• Store indoors in a dry place. Do not expose the
appliance to sunlight or freezing temperatures.
Recommended temperature range:
39.2°F (4°C) ~ 104°F (40°C).
Runtime
• When in ECO mode, the runtime is
approximately 30 minutes. When MAX power is
used, the runtime is approximately 20 minutes.
• Estimated runtime data was obtained by a
Tineco Laboratory.

Charging Time

• A full charge takes approximately 4-5 hours.
• Estimated data was obtained by a Tineco
Laboratory using ambient temperatures
between 39.2°F (4°C) to 104°F (40°C).
Indicator
When in Use
Full power
Medium power
Low power
Low power, please
charge.
Off: no power or
battery malfunction.
21
During Charging

MAINTENANCE

Note:
• For optimal performance and to prevent odors,
always clean and dry DWT, floater, filters, brush
roller, brush roller cover completely after each
use.
• Please make sure each part is installed correctly
or the appliance may not work properly.
• After maintenance, place the appliance on
the charging base vertically. Do not expose
the appliance to direct sunlight, and store it
indoors in a dry place.
Main Body
1.To reduce the risk of injury, switch off before
performing maintenance.
Fig.D-1
2.Use a cloth to clean the surface with a neutral
detergent. The cloth should be dry to prevent
water from entering the appliance.
Fig.D-2
Indicator blinking:
CWT is empty.
Indicator blinking:
DWT is full or
channel has a
blockage.
Indicator blinking:
brush roller is not
installed or has a
blockage.
Indicator blinking:
appliance is in need
of self-cleaning.
Indicator blinking
successively.