Troubleshooting; Disposal/Environmental Protection - Parkside Pstda 20-Li C3 Traduction Des Instructions D'origine

Remove the rechargeable battery from the
device before storing the device (see the

Troubleshooting

The following table will assist you in fixing faults:
Problem
Device does not start
Device works with interrup-
tions
Poor sawing performance
Saw blade quickly becomes
blunt
Disposal/
environmental
protection
Remove the battery from the device and
recycle the device, battery, accessories
and packaging in an environmentally-
friendly manner.
separate operating instructions for the bat-
tery and charger).
Possible cause
Rechargeable battery (29)
not inserted
On/Off switch (2) is broken contact the service centre.
Rechargeable battery (29)
discharged
Defective motor
Internal loose contact
On/Off switch (2) is broken contact the service centre.
Saw blade (16/17) unsuit-
able for the workpiece to be
processed
Saw blade (16/17) blunt
Low battery power
Incorrect sawing speed
Saw blade (16/17) unsuit-
able for the workpiece to be
processed
Too much pressure applied
Sawing speed too high
The symbol of the crossed-out wheeled bin
means that this product must not be dis-
posed of as unsorted municipal waste at
the end of its useful life.
Troubleshooting
Inserting the battery,
p. 36
Charge the battery (see the
separate operating instruc-
tions for the rechargeable
battery and charger)
contact the service centre.
contact the service centre.
Use a suitable saw blade
(16/17)
Use a new saw blade (16/
17)
Charge the battery (see the
separate operating instruc-
tions for the rechargeable
battery and charger)
Adjust sawing speed
Use a suitable saw blade
(16/17)
Reduce the pressure
Reduce the sawing speed
Waste electrical and electronic
equipment (WEEE) must not be
disposed of with domestic waste.
GB MT
37