Security Precautions; User Information - VINCENT SAV-C1 Manuel D'utilisation

SECURITY PRECAUTIONS

This appliance was produced under strict quality controls.
It complies with all established international safety standards.
Nonetheless, the following instructions should be fully read and
observed in order to prevent any hazard:
Do not open the appliance! RISK OF ELECTRIC SHOCK!
There are no parts in the appliance that require maintenance by the user.
Maintenance/Alterations
All equipment that is connected to the domestic
mains voltage can be dangerous to the user if not
handled properly. Leave maintenance work to
qualified professionals. The product is only permit-
ted for connection to AC 230Volt/50Hz, for eart-
hed sockets and use in enclosed areas. Altering
the product or manipulating its serial number voids
the warranty. After a fault, leave the appliance's
fuse to be replaced only by a professional with
one of the same kind.
Power Cable Connection
Always pull the plug and never the power cable if
you want to disconnect the appliance from the
mains power. Make sure when setting up the app-
liance that the power cable is not squashed, sever-
ely bent or damaged by sharp edges. Do not touch
the power lead with wet or damp hands. Use the
power cable supplied or another one from Vincent.
Moisture/Heat/Vibration
Contact of electrically operated equipment with
liquids, moisture, rain or water vapour is dange-
rous for such equipment and the user and must be
avoided without fail. Take care that no liquids or
objects get inside the appliance (ventilation slots
etc.). It must be disconnected from the mains power
immediately and examined by a professional if
this happens. Never expose the appliance to high
temperatures (direct sunshine) or strong vibration.
Switching Off
Switch the appliance off every time before you con-
42 Vincent
nect or remove other components or loudspeakers,
disconnect or connect it to the mains power, leave
it unused for a longer period or want to clean its
outside. On all amplifiers and receivers, wait
approx. 1 minute after this before disconnecting or
reconnecting the cable.
Heat Build-up
All amplifiers generate heat as part of their
design. Make sure that a gap of 5 cm remains
around the appliance and that the surrounding air
can circulate (do not install in enclosed cupbo-
ards). Vents must not be covered up.
Volume
The maximum tolerable volume is always reached
well below the maximum possible setting on the
amplifier. Be careful with the volume setting, there-
fore, in order to prevent damage to hearing. So that
you do not expose yourself to high volumes uninten-
tionally, always set to a low level before changing
the input channel.
Cleaning
Pull out the plug before cleaning the outside of the
product. Whenever possible, use a soft, lint-free
cloth that has been dampened. Do not use abrasi-
ves, solvents, thinners, flammable chemicals, polis-
hes and other cleaning products that leave marks.
ON
Batteries
Take note of the instructions for using batteries in
OFF
the chapter "Remote Control".

USER INFORMATION

Setting up the appliance
How the system is set up has an effect on the
sound quality. Therefore only place it on a suitab-
le, stable surface. To make the most of your
system's sound quality, we recommend placing the
equipment on Vincent racks and not putting them
on top of each other.
Old electronic equipment
This appliance is subject to the conditions set out
in the European Directive 2002/96/EC, whose
implementation is regulated in Germany by the
Electrical and Electronic Equipment Act (ElektroG).
This is identified by the symbol of a crossed out
waste bin on the appliance.
What this means for you as a consumer:
All old electrical and electronic equipment that is
no longer used must be disposed of separately
from domestic waste using places provided by the
authorities. By doing so you can prevent damage
to the environment and help to encourage manu-
facturers to produce more durable or reusable pro-
ducts. For further information about disposing
your old appliance, please consult your local aut-
hority, waste disposal agency or the shop where
you bought the product.
CE sign
This appliance complies with the current EU direc-
tives about attaining the CE mark and thus meets
the requirements for electrical and electronic
equipment (EMC regulations, regulations and
regulations for low voltage equipment.)
Declarations
This document was written by Andreas Böer. It is a
product of Sintron Vertriebs GmbH, 76473
Iffezheim and may not be copied or distributed part-
ly or in full without express, written consent.
Vincent is a registered trademark of Sintron Vertriebs
GmbH, 76473 Iffezheim.
„Dolby", „Prologic II", „Dolby Digital EX", the
Double-D-Symbol, "dts", „dts Surround", „dts-ES",
the dts-Logo, „HDCD" and „High Definition
Compatible Digital" are registered trademarks of
their owners.
Vincent works continually to improve and develop its
products. Therefore, the appearance and technical
design of the appliance are subject to changes, as
long as they are in the interest of progress.
The content of these instructions is for information
purposes only. It can be changed at any time without
prior notice and does not constitute any obligation
on the part of the trademark's owner. The latter assu-
mes no responsibility or liability for errors or inaccu-
racies, which may be included in these operating
instructions.
Explanation of the symbols
The lightening bolt tells you that dangerous
voltages are present in the appliance, which
can cause an electric shock.
This symbol brings your attention to
particularly important information regarding
operation and maintenance.
This symbol identifies useful information
and advice about how to handle the
appliance.
Vincent 43