Sony SU-LW1 Mode D'emploi page 16

Step 6: Install the display on the Plate Unit
WARNING
Do not connect the power cord to a wall outlet before the installation is completed. If the power cord is
pinched, a short circuit may occur, causing an electric shock.
Be careful not to stumble over the cables or the display.
1
KLV-26HG2
Rear of the display
KDL32XBR950/KLV30XBR900
Rear of the display
16
(US)
The supplied screws
(+PSW5 × L16)
Mounting Hook Units
Soft cloth
The screws removed
in Step 5
Mounting Hook Units
Soft cloth
Align the holes on the Mounting
Hook Units with the corresponding
holes on the rear of the display.
Secure them to the display using
four screws.
For the KLV-26HG2, use the screws supplied (+PSW5
× L16). For the KDL32XBR950 and the KLV30XBR900,
use the screws you removed in Step 5.
Notes
• Lay the display face down on a soft cloth.
• When using an electric screwdriver to tighten the
screws, the torque must be approx. 2 N m.
•