Setting The Group - Mitsubishi Electric PAC-SF44SRA Manuel D'utilisation

6-1-1. Setting the group

• Register the indoor unit, LOSSNAY, slave system controller and local remote controller for
each group. (Register the LOSSNAY to be interlocked with the indoor unit using the
interlocked unit setting.)
• If the group setting information has already been set and no operations are made on this
screen for ten minutes, the display will automatically switch to the Collective Setting/Monitor
screen. (The details being set will be deleted.)
1. Select the group
Select the group in which the unit is to be registered.
2. Select the unit
Select the unit, etc., to be registered in the group selected in step 1.
3. Registering the unit into a group
4. Deleting a unit from a group
5. Searching for registered units
Go to step 6-1 (4) or 6-1-2.
1. Select the group
(1) The group operation status display ((
the GROUP
The display will move in reverse when the GROUP
(2) After the group is selected, if a unit is registered in the group the minimum address No. unit
will appear. The attributes for that group will appear after two seconds.
Displayed details
) in following example) will move in order each time
switch is pressed, and the group No. display section will also change.
{
Set temperature display section ... Address No.
Group No. display section ............ Address No. attributes
switch is pressed.
19