+> continued
| STEP 4| Connecting the
Power
Connect the mains lead to the mains after
you have made all the above connections.
to mains
Demo mode
The demo mode appears in the display
when you. connect the mains lead to the
mains. To deactivate the demo mode,
press DISPLAY /DEMO when the
system power is off.
Note
When you turn on the system power for the
first time, the disc tray starts rotating.
You can operate the CD player after the
disc tray stops rotating and "CD NO DISC"
appears in the display.
Chapter 1: Setting Up
er
ee)
Inserting the Batteries
Insert two R6 (size AA) batteries in the
supplied remote for remote control.
4
i Open the lid.
2 Insert two R6 (size AA) batteries.
Match the + and — to the diagram in the
battery compartment.
3 Close the lid.
Battery life
You can expect the remote to operate for
about six months (using Sony SUM-3 (NS)
batteries) before the batteries run down.
When the batteries no longer operate the
remote, replace all the batteries with new
ones.
To avoid battery jeakage
7
If you are not going to use the remote for a
long time, remove the batteries to avoid
damage caused by corrosion from battery
leakage.
Setting the Clock
The built-in clock shows the time in the
display.
3,5
DEMO
DISPLAY/
1 Press CLOCK SET.
The hour indication begins flashing.
flashing
2 Set the current hour by pressing < or >
(CURSOR CONTROL) until the correct
hour appears.
flashing
3 Press ENTER/NEXT.
The minutes indication begins flashing.
flashing
A set the current minute by pressing < or
> until the correct minute appears.
flashing
5 Press ENTER/NEXT.
The clock starts running and the upper
dot flashes. Use the time signal to set the
clock accurately. The upper dot flashes
for the first half of a minute (0 to 29
seconds), and the lower dot flashes for
the last half of a minute (30 to 59
seconds).
To check the time
Press DISPLAY / DEMO a few times.
The current time appears fora few seconds.
To correct the clock setting
Repeat steps 1 to 5.