Grass Catcher; Starter Handle; Convert The Lawn Mower - Husqvarna LC221Ai Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Grass catcher

Assembly of the catcher
1
Put the grass catcher frame into the grass bag with
the rigid part of the bag on the bottom. Make sure the
handle of the frame is outside of the top of the bag.
2
Secure the grass bag to the frame by using the quick-
action clips.

Starter handle

Install starter handle
1
Loosen the T-knob.
2
Hold the engine brake handle against the upper
handle.
ASSEMBLING AND ADJUSTMENTS
3
Grip the starter handle, slowly pull the engine starter
handle until the starter rope can slip into the loop of
the rope guide.
4
Tighten the T-knob.

Convert the lawn mower

Your lawn mower was shipped ready to be used in
mulching mode.
The mulching mode will recut the grass clippings many
times, which will reduce the clippings in size so that as
they fall onto the lawn they will disperse into the grass and
not be noticed. In addition, the mulched grass will
biodegrade quickly to provide nutrients for the lawn.
Use rear bagging to collect the grass clippings within the
grass catcher.
WARNING! Do not run your lawn mower
!
without rear door closed or approved
grass catcher in place. Never attempt to
operate the lawn mower with the rear
door removed or propped open.
Rear bagging
1
Lift the back shield and remove the mulch plug.
2
Lift the back shield and place the grass catcher frame
hooks onto the grass bag brackets.
3
Release the back shield and allow it to rest on top of
the grass bag frame.
English
9

Publicité

Chapitres

Table des Matières
loading

Table des Matières