Error Codes - Gaggia PLATINUM SWING SUP 034NR Mode D'emploi

32

ERROR CODES

GUIDE MESSAGE THAT APPEARS
out of service (xx)
restart to fix...
close coffee bean lid
fill container with coffee
insert the brew group
insert grounds drawer
empty grounds
empty grounds drawer
close door
fill the water tank.
empty drip tray
change the filter
carafe missing
milk island missing
descale
stand-by...
HOW TO REMOVE THE MESSAGE
Where (xx) identifi es an error code.Turn off and after 30
seconds turn the machine on again to restore normal operation.
If the problem persists, call the service centre and give the code
(xx) shown on the display.
Close the coffee bean hopper cover to be able to make a
beverage.
Put coffee beans into the bean hopper.
Insert the Brew Group in its place.
Insert the coffee grounds drawer.
Warning that does not block the machine. Proceed as for the
next alarm.
Remove the grounds drawer and empty the grounds into an
appropriate container (See page 30 steps 1 and 2).
Note: The grounds drawer must be emptied only when the
machine requires it and when the machine is turned on. If
you empty the drawer with the machine turned off it will not
record the emptying operation.
In order for the machine to operate, the side door must be
closed.
The tank must be removed and refi lled with fresh drinking water.
Open the side door and empty the drip tray located under the
Brew Group.
Warning: if this operation is performed when the machine is
on, it will record the coffee grounds drawer emptying and
will reset the relative counter; therefore, it is necessary to
empty the coffee grounds as well.
The Aqua Prima fi lter must be replaced in the following cases:
1. 60 litres of water have been dispensed;
2. 90 days have passed since its installation;
3. 20 days have passed and the machine has not been used.
Note: this message only appears when "on" has been selected
in the water fi lter function (See page 21).
The steam knob has been turned to the
the Milk Island has not been installed or the carafe is not
positioned correctly. Install the Milk Island or position the carafe
correctly.
Otherwise, turn the knob until it is in the rest position ( ).
A descaling cycle must be performed on the machine's internal
circuits.
Press the button.
position and either