Kopp Free-control Mode D'emploi page 45

GB
Malfunction
Radio receiver
sometimes switches
or sometimes
does not when the
radio wall switch is
activated.
RF Universal
transmitter does
not switch correct
or transmit a per-
manent signal (LED
permanent ON)
Cause
The devices are at the
transmission range
limit
Interference sources
influence the radio
transmission. (e.g.
other radio transmit-
ters, modified climat-
ic conditions, ...)
The potential-free
Wrong modus.
RF Universal trans-
mitter was wrong
wired.
Remedy
Install the radio wall switch and/or radio
receiver at a different location, if possible.
Install the radio wall switch and/or radio
receiver at a different location, if possible.
Clean the main switching contact (of a push-
button, switch, potential-free contact maker,
etc. ...), if possible, or replace it by a „new"
switching contact.
Chose right modus - page 7. Deled RF receiver
memory complete and teach again new.
Correct the RF receiver wiring. Deled RF
receiver memory complete and teach
again new
45