Kopp Free-control Mode D'emploi page 38

GB
Dimming mode - Sequence pushbutton
Description
Application
Connectivity
DIP switch
Setting
Pinning diagram
1
Switching
operation
Dimming
operation
LED signalling
38
Connection of the universal radio transmitter to a customary sequence
pushbutton used for dimmer activation.
Individual dimming of up to two radio receiver groups.
One sequence pushbutton can be connected to the universal radio
transmitter, if both sequence pushbutton contacts should be used.
Up to two sequence pushbuttons can be simultaneously connected
to the universal radio transmitter, if only one sequence pushbutton
contact of either sequence pushbutton is used.
Select mode C.
Set DIP switch position 1 to ON
Set DIP switch position 2 to OFF
1
2
3
4
1
1 If „OFF", inch pushbutton 1x: radio signal „ON" is transmitted
1
1 If „ON", inch pushbutton 1 x: radio signal „OFF" is transmitted
1
Press pushbutton and keep it pressed:
Dimming operation starts. The consumer (lamp) light/dark is
activated. At the desired luminosity, release the pushbutton
With every signal emission, the universal radio
transmitter's LED flashes shortly.
Connect 1st pushbutton to the input channel 1/2.
Connect 2nd pushbutton to the input channel
3/4.
All switch positions (2x ON, 2x OFF) must be
teach to the receiver.
actuation point on operating rocker