Kopp Free-control Mode D'emploi page 43

GB
6. Ready - the universal radio transmitter is
connected to the radio receiver.
7. After completing the teach-in procedure
adapting the universal radio transmitter to
the radio receiver, the universal radio
transmitter's installation can be
completed.
Delete programmed assignment:
(Applicable to Free-control radio receivers.
Follow the appropriate Operating Instruc-
tions.)
1. Press the PROG. button of the radio recei-
ver with the included programming pin
and keep it pressed for approx. 10 seconds
until the LED (red) lights up and
subsequently goes off.
2. After approx. 3 seconds, the LED lights up
of the RF receiver.
3. After additional 7 seconds, the LED flashes
twice and extinguished then.
4. Ready - Program memory was complete
deled.
Maintenance-free
The Free-control installation is maintenance-
free. It is sufficient to change the batteries
of battery-operated users from time to time.
(See recommendation in the „Technical data"
section)
Recommendation: For complex circuits/
installations, we recommend changing the
batteries of all radio transmitters at the same
time, as soon as the battery of the first user
must be replaced due to an empty battery.
Troubleshooting
Numerous factors can have an effect on the
proper function of the radio system. In the
following, the most familiar malfunctions,
their causes and their remedies are briefly
explained.
43