Kopp Free-control Mode D'emploi page 35

GB
Pushbutton
Description
Application
Connectivity
DIP switch
Setting
Pinning diagram
1
Switching
operation
LED signalling
actuation point on operating rocker
Connection of universal radio transmitter to a customary pushbutton.
Individual control of up to two radio receiver groups.
Up to two pushbuttons can be simultaneously connected to a universal
radio transmitter.
Select mode B. To activate the mode B, remove battery for at least 30
seconds and then reinsert the battery.
Set both DIP switch positions to „OFF".
1
2
3
4
1
1 If „OFF", inch pushbutton 1x: radio signal „ON" is transmitted
1
1 If „ON", inch pushbutton 1 x: radio signal „OFF" is transmitted
With every signal emission, the universal radio transmitter's LED
flashes shortly.
Connect 1st pushbutton to the input
channel 1 / 2.
Connect 2nd pushbutton to the
input channel 3 / 4.
When used with RF receiver with
the function push button, note
the following:
In the adjustment „I" must be set he
Mode „C - dim-function" Only then
the device is switched on as long as
the push button is pressed.
35