Publicité
Les langues disponibles
Les langues disponibles
GB
Teach-in procedure
Assign the radio transmitter to a radio receiv-
er (using the example of a newly installed
radio wall switch):
1. Connect radio receiver to voltage.
2. Press the PROG. button of the radio
receiver with the included programming
pin and keep it pressed for approx.
2 seconds until the LED (red) lights up.
Standard LED signalling of radio receivers
(Please follow the respective Operating Instructions.)
Display
LED lights up
LED goes off 1x
LED flashes at high
frequency
LED flashes 3x long
LED flashes 2x
LED signalling of the universal radio transmitter
LED lights up for approx. 0.5 s
LED flashes briefly 6x
42
3. The teach-in mode is now activated for 20
seconds.
4. Operate then at the desired universal radio
transmitter input channel the connected
pushbutton / switch. It is best to make
contact between the connecting wires
of the universal radio transmitter input
channel. As a result, a radio transmission
signal is triggered.
5. The radio receiver's LED goes off 1x.
Function
Teach-in mode activated for 20 seconds.
Positive acknowledgment. Radio transmitter was correctly
programmed.
Fault indication. One and the same radio transmitter should
be repeatedly taught-in.
Fault indication. Occupied memory.
Positive acknowledgment. Program memory of the radio
receiver was completely deleted.
Radio signal is transmitted
Empty battery
Publicité
