Intended Use; Commissioning; Connecting Pneumatic Tools - Festool CTL 26 E Notice D'utilisation D'origine

English
Mobile dust extractors
Weight
5

Intended use

Mobile dust extractor suitable for
– extracting dust up to 1 mg/m³ according to
dust class L,
– extracting water,
– for increased loads during commercial use,
according to IEC/EN 60335-2-69.
The user is liable for improper or non-in­
tended use.
6

Commissioning

WARNING
Unauthorised voltage or frequency!
Risk of accidents
► Observe the specifications on the ma­
chine's name plate.
► Observe country-specific regulations.
6.1 Initial commissioning
► Insert the filter/disposal bag [2].
► Fit the cord holder [3].
► Connect the suction hose [4].
6.2 Connecting the mobile dust extractor
WARNING
Risk of injury from tools starting up unex­
pectedly
► Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con­
nected tool is switched off.
The switch [1-8] serves as an on/off switch.
Switch position "0"
Appliance socket [1-3] is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket [1-3] is connected to the pow­
er, the mobile dust extractor starts.
14
CTL 26 E
CTL 36 E
CTL 48 E
CTL 26 E AC
CTL 36 E AC
CTL 48 E AC
"Auto" switch position
Appliance socket [1-3] is connected to the pow­
er, the mobile dust extractor starts when the
connected tool is switched on.
► Insert the plug into an earthed socket.
Pull the plug from the socket when the
machine is not in use and prior to main­
tenance and cleaning work.
6.3 Connecting electric power tools
WARNING
Risk of injury
► Observe the maximum appliance socket
connected load (see chapter "Technical da­
ta")
► Switch off the electric power tool.
► Connect the electric power tool to the appli­
ance socket [1-3].
Special features of CTL26 E SD
– CTL 26 E SD E/A: socket module with auto­
matic switch-on function for the use of two
electric power tools: e.g. 2 sanders, 1 jig­
saw + 1 sander
CTL 26 E SD: Socket module with perma­
–
nent power supply for use as extension ca­
ble: e.g. charger, lamp, etc.
6.4

Connecting pneumatic tools

WARNING
Risk of injury
► Switch off the air tool.
Automatic on/off switch for air tools (CTL
36/48 E LE, CTL 36/48 E LE AC or accessories)
with compressed air module in module
slot [1-2]
Recommendation:
– Attachment of service unit VE (495886):
compressed air filtered and lubricated
– Use of IAS system with IAS connector
(454757) for Festool air tools
13.9 kg
14.4 kg
18.8 kg
14.7 kg
15.2 kg
19.6 kg