Accessories; Standard Accessories - Hitachi S 18SB Mode D'emploi Et Instructions De Securite

English
CAUTION: Repair, modification and inspection of Hitachi Power Tools must be carried
out by a Hitachi Authorized Service Center.
This Parts List will be helpful if presented with the tool to the Hitachi
Authorized Service Center when requesting repair or other maintenance. In
the operation and maintenance of power tools, the safety regulations and
standards prescribed in each country must be observed.
MODIFICATIONS:
Hitachi Power Tools are constantly being improved and modified to incorporate the
latest technological advancements.
Accordingly, some parts (i.e. code numbers and/or design) may be changed without
prior notice.
WARNING:
NOTE:
Accessories are subject to change without any obligation on the part of the HITACHI.

STANDARD ACCESSORIES

7" (180 mm) Sanding disc (Grain size: P50) (Code No. 314090) ..................................... 1
Rubber pad (Code No. 953255) ......................................................................................... 1
Wrench (Code No. 937913Z) .............................................................................................. 1
Side handle (Code No. 937089) ......................................................................................... 1
NOTE:
Specifications are subject to change without any obligation on the part of the HITACHI.
14

ACCESSORIES

ALWAYS use Only authorized HITACHI replacement parts and
accessories. Never use replacement parts or accessories which are not
intended for use with this tool. Contact HITACHI if you are not sure
whether it is safe to use a particular replacement part or accessory
with your tool.
The use of any other attachment or accessory can be dangerous and
could cause injury or mechanical damage.