Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ACCESSORIES
WARNING:
STANDARD ACCESSORIES
Rubber Pad (Code No. 953255) ........................................................................................... 1
Wrench (Code No. 937913Z) ............................................................................................... 1
Side Handle (Code No. 981205) .......................................................................................... 1
NOTE:
Accessories are subject to change without any obligation on the part of the HITACHI.
APPLICATIONS
Sanding metal surfaces.
Preliminary sanding of metal surfaces before painting, rust removal, removing old paint
before repainting.
Finishing woodwork, correcting projections of timbers from joints or assemblies.
Preliminary sanding of wood surfaces before applying paint.
Polishing or shining painted metal surfaces, such as those of automobiles, trains,
elevators, refrigerators, sewing machines, washing machines, metal appliances, etc.
Polishing varnished surfaces of wooden furniture, etc.
Shining synthetic resin or ebonite products.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms to the power source requirements
specified on the product nameplate.
CAUTION: Do not operate on Direct Current power source.
2. Power switch
Ensure that the switch is in the OFF position. If the plug is connected to a receptacle while
the switch is in the ON position, the power tool will start operating immediately and can
cause serious injury.
3. Extension cord
When the work area is far away from the power source, use an extension cord of sufficient
thickness and rated capacity. The extension cord should be kept as short as practicable.
WARNING:
Accessories for this power tool are mentioned in this Instruction
Manual.
The use of any other attachment or accessory can be dangerous and
could cause injury or mechanical damage.
Damaged cord must be replaced or repaired.
English
11
Publicité
Table des Matières
