9.4 door opening
It is recommended to carry out cleaning with the
boiler switched off and cold.
• Open the fire box door and ash drawer using
the dedicated key (a).
A
9.5 Cleaning the combustion chamber
and ash drawer
Check that the burn pot is clean to make sure the
combustion air flows freely through the holes of
the burn pot itself.
• Vacuum the ash accumulated in the burn pot
(Fig. 58).
ATTENTION: remove the ash from the
combustion chamber because the salts
present cause corrosion of the metal. In
addition, the ash could block the pas-
sage of air, varying the development of
the flame which, if it approaches the
glass, would increase corrosion.
• Remove the ash drawer and empty it, making
sure to remove any residue in the compart-
ment where it is contained (Fig. 58).
Using an ash vacuum can simplify the
cleaning operations
004778640 - 10/02/2021
ITALIANO
9.6 Cleaning the turbulators
It is recommended to carry out cleaning with the
boiler switched off and cold.
• Lift and lower the turbulators (a) 2/3 times.
Fig. 57
ENGLISH
FRANÇAIS
Fig. 58
A
Fig. 59
95